If you require a lead in cable to your house, we can provide an underground or an overhead connection.
An underground connection requires a Telstra 23mm Lead in Conduit from the pit to the house prior to connection. If you don’t have any underground conduit we can arrange a site visit for civil engineering.
Typical path of the lead-in cabling to a single dwelling
a) Electricity enclosure on the same side of the building as the property entry point
![Lead-In-Cabling-left](https://www.melbournedatacabling.com.au/wp-content/uploads/2018/05/Lead-In-Cabling-left.jpg)
b) Electricity enclosure on the opposite side of the building to the property entry point
![Lead-In-Cabling-right](https://www.melbournedatacabling.com.au/wp-content/uploads/2018/05/Lead-In-Cabling-right.jpg)
Overhead lead in cabling
Overhead Lead in cabling can be provided (*if your existing lead in cable has been damaged and have an adjacent communications pole outside your house). A site visit will confirm this.
Clearance of aerial lines from the ground
The minimum ground clearances required for aerial lead-in cabling in residential areas are as follows:
- Over any private land not traversable by road vehicles – 2.7m
- Over any residential driveway – 3.5m
- Over any commercial/industrial driveway or private roadway – 4.9m
![Lead-In-Cabling-3](https://www.melbournedatacabling.com.au/wp-content/uploads/2018/04/Lead-In-Cabling-3.jpg)
Our staff are fully licensed technicians.
Phone cabling, internet cabling, cat6 data cabling & even the NBN, within Australia requires a licensed technician to perform installation or maintenance on residential and commercial structures.
So if you’ve just got that NBN connected or need a repair / require an extra phone point installed, you’ll still need a registered approved cabler to install and terminate your cabling.
Get a quote
Simply fill out the form below to get started! We will respond promptly